Creport3000 Series Medical Pendant equipment used in modern clean operation rooms and general operation rooms. It is an ideal and practical endoscopic workstation . This pendent is a practical equipment used in modern clean operation rooms and general operation rooms . All kinds of terminals such as for medical gas , electricity , network are all gathered on the control board.
Creport3000 Series Medical Pendant Anesthesia Pendant,Ceiling Pendant,Hospital Pendant,Medical Gas Pendant Shandong Lewin Medical Equipment Co., Ltd. , http://www.lewinmed.com
Safety requirements for threshing threshing
Silicon Valley machinery threshing operations and other agricultural operations are very different, if you do not strictly abide by these rules, the consequences are very serious, light injury to humans, burned food and grass; seriously jeopardize personal life. The main points of safe operation are as follows: Martian collectors must be installed on the exhaust pipes of tractors and diesel engines that participate in threshing operations. The carbon deposits and dust in the Mars collector must be removed during shift maintenance. Do not stack flammable materials such as straw or firewood within 2 meters of the tractor or diesel engine to prevent fire. 2. Fireworks in the threshing floor are strictly prohibited. Workers must not bring matches, lighters, etc. into the venue. There must be adequate and effective fire protection equipment, such as sandbags, fire extinguishers, fire protection ditch, etc., and be placed in a fixed location. 3. When the motor is used to drive the thresher, the power switch must be installed in a wooden box. The wooden box must be 1.7 meters above the ground. Wires shall not be hung on the trees. Special poles shall be provided. The height of the wires from the ground shall be more than 3.5 meters. Three-phase cable should be used for motor wiring, and there must be no connector in the middle. The outer shell of the motor should have a ground wire. The conductor depth of the wire should be more than 1 meter below the ground, and the conductivity is good and reliable. Multiple power-using devices must not share one switch and must be set separately. 4. The threshing machine shall be equipped with protective cover plates for belts, gears, transmission belts and other transmission parts. No belts can be attached to the work and must be parked before being attached. 5. The maintenance, adjustment, troubleshooting, etc. of the machine must be stopped and shut off before the engine can be switched off. If the motor is used as a power source, the power supply must be cut off. Otherwise, the above work cannot be performed. 6. In operation, motors, diesel engines, tractors, etc. must not be overloaded and over-speed work must not be allowed; nor can the throttle be suddenly increased to prevent fire from sparking. 7. When feeding into the valley, it is necessary to feed the machine after shaking it up so that no hard objects such as stones enter the machine. The rice and grains that must be fed by hand should be gradually fed from the tip, and should not be put too much or too much, and must not be fed from the back of the straw. The amount fed should be uniform. Thresher feed inlet baffle is strictly prohibited. 8. The inspection hole of the thresher must be covered, and the cover plate must not be removed at will. The damage should be promptly repaired. 9. The platform, bezel, and shroud of the thresher must be securely fastened and the loose screws must be fastened in time. 10. When working at night, do not use open flame lighting. The light should be more than 2 meters away from the ground. The power line should be more than 4 meters above the ground. It should be firmly fixed and not attached to the tree. 11. Personnel who participate in threshing operations must conduct safety knowledge education before work. At work, the sleeves should be fastened and women should cover their hair in their hats. The jam of the threshing machine must be turned off and shut off, or the power supply must be shut off before removing the jam. Do not remove it by hand. 13. Repaired rotating parts such as fan blades, threshing drums, etc. After the repairs, it is necessary to do a dynamic balance test and use it only after passing the test. â—90 Dongling Road, Shenyang City (110161)