The boiler is called the “source of power, the source of heat”, and many places use boilers to prepare steam and hot water. The steam produced by the boiler is directly mixed with the cold water through the boiler fittings steam-water mixer, and the generated hot water is directly delivered to the user to meet the production process, heating, and living needs. In the whole boiler heating system, the boiler accessory steam-water mixer plays a key role. Whether or not the steam-water mixer is installed or not will affect the heater effect. The following small series summarizes the precautions for the installation and use of boiler parts and soda mixers for your reference.

1. At the beginning of the operation, there may be a slight water hammer, but it will disappear by itself soon.

2, adjust the water temperature: If the thermostat automatic control device is installed, you only need to set the required temperature on the control box. If only the manual control valve is installed, you only need to control the switch degree of the valve at any time.

3. When the system is used, if the heating temperature is slow, or the new installation system is heating up low, it is likely that the heater inner nozzle is blocked by the inclined hole, and it can be removed and cleaned.

4. Start and stop equipment: Before the system is put into use, first open the water side valve (water pump). After the water circulation (circulation) is normal, then open the steam valve to send steam to work normally: when closing the system, first close the steam valve , after closing the water side valve (water pump).