Check the cracks carefully. Put the parts in kerosene and soak for 30 minutes. After the removal, wipe the surface dry. Put a piece of chalk dust on the surface. Wait for a while, because the chalk ash absorbs the kerosene that leaked from the cracks and cracked. When the place is dark, the cracked part of the part can be found. In order to remove the rust from the rim, remove the rust on the rim. Apply a thin layer of talc between the inner and outer tires. Then lay the rim flat and put on the tire. Use a pedal or crowbar to pry the rim of the tire into the rim, insert the inner tube, and use the wire to fix the inflation valve in the rim inflation valve hole, and then install the other side of the tire. Starting from the corresponding position of the inflation valve, use a crowbar to push a part of the tire into the rim first, and then gradually install the tire from the inflation valve to both sides. At the same time, step on the tread with the foot in the position opposite to the inflation valve, and then step on the side, you can make The bead ring portion of the tire is gradually loaded into the rim. When the oil seal is installed on the crankshaft with a clever oil seal, the inner end face of the seal is easily distorted, resulting in oil leakage. Roll a piece of clean, thin cardboard into a trumpet roll. Put the roll on the shaft. Place the small end of the roll on the shaft end. Put the oil seal on the small end of the roll. Gently seal the oil seal with your hand. Rotate on the shaft, and the direction of rotation is consistent with the direction of reel rotation. When the seal is in place, slowly withdraw from the reel. The cable used to inspect the cable breakage pump in a clever way is likely to break due to repeated folding and twisting during use. Using a 220V power plug, connect a 220V, 15W light bulb to one of the power cables. Connect the two power cables to the two ends of a core wire in the cable. The light bulb is on after the power is connected. The line is open, otherwise it indicates that the core is broken. Then use both hands to hold the cable and force it to press in the middle for a period of time. If the light is on, the line is broken. Disconnect the power supply, cut the rubber sleeve with a knife, connect the broken wire, and wrap it with an insulating tape. When a cylinder of a multi-cylinder diesel engine with a broken cylinder method malfunctions, a commonly-used cylinder-cut method is used to judge. Use the broken cylinder method to pay attention to the following points: First, discharge the air in the diesel fuel pump to ensure correct judgment; place the throttle of the diesel engine at the position of the big throttle to prevent the engine from stalling; when loosening the high pressure tubing of a cylinder, pay attention to Look, listen carefully, see if the engine black smoke is reduced, hear the sound of the engine has no change, if there is no change before and after, indicating that the cylinder is faulty, should be further checked. Distributive fuel injection pumps do not have oil outlet valves, and each cylinder's fuel injection quantity interferes with each other. Therefore, the distribution pump cannot use the broken cylinder method to diagnose whether a cylinder is faulty.
All water based products have plenty of nutrients and water to support microbe growth under favorable conditions. Microbes invade water based products from multi-point sources, such as contaminated raw materials, poor plant hygiene, untreated water, and not properly preserved recycling materials. While adding in-can preservatives into the products should not excuse a factory from Good Manufacturing Hygiene Practices (GMHP), proper use of in-can preservatives coupled with GMHP can dramatically minimize the chance of microbial tolerance development, and assure unspoiled products to customers.
Sunshine Biotech supplies to all industrial biocides formulators with high quality BIT technical ingredients. Besides of BIT, we also provide its derivative, like BBIT, MBIT etc.
Biocide Technical Ingredients Biocide Technical Ingredients,Biocide Formula,Biocide Ingredients,Biocide Liquid Nanjing Sunshine Biotech Co., Ltd , http://www.sunshine-bio.com
